■ Battery
Note: Always switch off the power, and disconnect
the charger and any other device before removing the cover.
Avoid touching electronic components while changing the cover.
Always store and use the device with the cover attached.
S e t u p y o u r p h o n e
15
Remove the back cover
1. With the back of the phone
facing you, push down on the
back cover.
2. Slide the back cover toward
the bottom of the phone and
remove.
Remove the battery
After you have removed the back
cover, insert your finger into the
finger grip, and lift the battery
from its compartment.
Note: Always switch off the device, and disconnect the charger before
removing the battery.
UIM card slot
Your phone has a UIM (CDMA SIM) card slot
built into the mechanics. However, the UIM
is not functional in this phone model. Avoid
placing anything into the UIM card slot.
Replace the battery
1. Insert the battery,
gold-colored contact
end first, into the
battery slot.
2. Push down on the
other end of the
battery to snap the
battery into place.
S e t u p y o u r p h o n e
16
Replace the
back cover
1. Set the back cover on the
phone with the cover tabs
aligned with the slots in
the phone.
2. Slide the back cover
toward the top of the
phone until the back cover is securely in place.
Charge the battery
Note: Before you use a charger with this device, check its model number.
This device is intended for use when supplied with power from the AC-3
or AC-4 charger.
1. Plug the charger transformer into a standard ac outlet.
2. Insert the charger output
plug into the round jack
at the bottom end of
the phone.
After a few seconds, the
battery indicator in the
display starts to scroll from
bottom to top. If the
battery is completely
discharged, it may take a few minutes before the charging indicator appears
on the display or before any calls can be made.
The ACP-12, ACP-9, ACP-8, ACP-7, and the LCH-12
can also be used to charge
the phone, but must be used with the CA-44 adaptor included in the box.
1. Plug the charger transformer into a standard ac outlet.
S e t u p y o u r p h o n e
17
2. Insert the charger output plug into the CA-44 adapter jack. Insert the CA-44
plug into the jack on the bottom of the phone.
Warning: Use only batteries, chargers, and enhancements approved by
Nokia for use with this particular model. The use of any other types may
invalidate any approval or warranty, and may be dangerous.